iSW82TS 4 wires curtain motor and DC866A Bistable switch and DC86 flush box kit

iSW82TS 4 wires curtain motor and DC866A Bistable switch and DC86 flush box kit will provide you simple solution for your motorised curtain track, 82TS curtain motor is standard model, it has built-in transformer,electronic memory limit,power on and off manual, resistance and stop function etc. features, but there is no built-in RF receiver, so you can not use the RF remote to control the curtain track, you need to hardwire the 82TS motor to wall switch like DC866A bistable (toggle) switch to control the motor open, close and stop.

Meanwhile, if you like to control this curtain motor, then you can use the Fibaro Roller Shutter 2 ( purchase separately ) to control it via Z-Wave controller like Fibaro HC 2 .

82TS curtain motor is fully compatible with Fibaro Roller shutter 2 Z-wave module without of any issue. We have tested all of Fibaro RS2 , Qubino Flush shutter and TBK roller shutter controller with 82TS curtain motor before, sometimes we confused each other, now we can confirm only Fibaro Roller Shutter 2 Z-Wave module is fully compatible, the other two are not. So from now on, if you want to use the Z-Wave module to control the motorised curtain track, we will recommend you to use the 82TS 4 wires standard curtain motor with Fibaro RS2 module, it can do auto calibration and position controlling through the Z-Wave controller.
Programing and setting are pretty simple and easy:
1, Q1 of the Z-Wave module should connect to the black colour wire on the 82TS motor, Q2 should connect to the Brown colour wire on the motor, to make sure the moving direction will match the direction on the interface of the Z-Wave controller ;
2, To set up the limit position, click the open (up) button on the interface of the Z-Wave controller, the tackle will hit the side edge once, then click the close (down) button, for the two way curtain track, the two tackle will hit each other in the middle of the track, for the one way track, the tackle will hit the other side edge once, then the 82TS will remember the limit position automatically;
3, Click calibration button on the interface of Z-Wave controller, the motorised curtain track will automatically fully open, fully close and fully open again. All done, it's pretty simple.
4, In case of the power blackout, then if you pull the tackle by hand or you remove the motor from the track, move the tackle, the limit position will be changed, then you need to reset the limit position again,
you just need to click the open and close button a couple times, the limit position will be set up again, carry on number 3 step again, then it will be all good again.